top of page

How to Prevent Asphalt Cracks in Arkansas: A Practical Guide

Writer: Kent Wilson
Kent Wilson
Oct 20
8 min read

Updated: 6 days ago

Start With the Causes of Asphalt Cracks

If you want to know how to prevent asphalt cracks in Arkansas, start with what actually causes them. Asphalt fails from the inside out, and the crack is just the symptom you finally see.

Three forces do most of the damage:

  • Water seeping into the pavement base

  • Traffic flexing a surface that has lost support

  • Heat and sun aging the asphalt binder

Arkansas makes all three worse. Our summers bake the surface, and our freeze-thaw winters work water deeper into every opening.

Weather, Traffic, and Water: The Three Main Stressors

Water is the biggest threat. It gets into a small opening, sits in the base, and softens the material holding your pavement up. Traffic then pumps that weak spot until the surface breaks.

Heat finishes the job. Sun exposure dries out the binder that holds aggregate together, leaving the surface brittle and prone to hairline cracks.

Why Small Cracks Turn Into Big Problems

A hairline crack is cheap to treat. Ignore it for a season, and water turns it into a wider gap, then alligator cracking, then a pothole.

That progression is why early intervention matters. Crack repair done early protects the pavement base. Patching a pothole later just fixes the result, not the cause.

Watch Out Sealing over a wet or dirty crack traps moisture underneath. The seal fails within a season, and water keeps working on the base the whole time. Clean and dry the crack first, every time.

Fix Drainage and Grade Before You Fix Cracks

Crack sealing on a lot that holds water is wasted work. Standing water softens the base, and new cracks appear beside the ones you just filled.

Look for these before scheduling any repair:

  • Ponding after rain in low spots

  • Cracks running along the edge of the pavement

  • Weeds growing out of joints

  • Soil or mulch piled against the asphalt edge

Fixing grade and drainage first addresses the root cause. Sometimes that means a small regrade or a repaired shoulder. Other times it means routing water away from the lot entirely.

Asphalt Crack Sealing: What It Does and When to Schedule It

Asphalt crack sealing is the process of cleaning a crack, drying it, and filling it with a flexible sealant that keeps water out. It does not restore structural strength.

Worker using a hot-applied sealant wand to prevent asphalt cracks in a commercial parking lot.

Schedule crack sealing before the wet season, not during it. In Northeast Arkansas, that usually means late summer into early fall, when cracks are open and dry. Spring work is possible but rain makes timing harder.

Hot-Applied Rubberized Sealant vs. Cold Patch

Hot-applied rubberized sealant is a standard for working cracks. It flexes with the pavement through freeze-thaw cycles and bonds tightly to clean edges.

Cold patch is a temporary fix. It works for a quick pothole repair, but it may not flex and can loosen within a season.

Method

Best For

Durability

Notes

Hot-applied rubberized sealant

Working cracks, preventive maintenance

Long-lasting, flexes with pavement

Needs clean, dry crack

Cold patch

Temporary pothole repair

Short-term

Can loosen with traffic

Sealcoating

Surface protection

Moderate

Not a crack fix

How Asphalt Sealcoating Protects Against Surface Deterioration

Asphalt sealcoating is a protective coating applied over the whole surface to slow sun damage and seal minor surface voids.

Think of it as sunscreen for your lot. It slows aging and improves appearance. It also makes the surface easier to clean and sweep.

Sealcoating works best after cracks are sealed and patches are done. Coating over open cracks hides them for a few months at most.

Pro Tip New asphalt needs time to cure before sealcoating. Ask your contractor about timing rather than coating a fresh lot right away. Coating too early can trap oils and keep the surface soft.

Build an Asphalt Parking Lot Maintenance Schedule

A written schedule beats reactive repairs every time. Most property managers who experience major damage often find the problem when a tenant complains, rather than when the crack is still a hairline.

The schedule below is the one we recommend to commercial property owners, churches, schools, and medical facilities across Northeast Arkansas. It is built around the seasons here, not a generic national calendar.

A Recurring Inspection Calendar

Timing

What to Do

Why It Matters

Early spring (after the last freeze)

Full walk-through; log every crack, pothole, and ponding spot

Freeze-thaw damage from winter shows up now, before summer traffic widens it

Late spring

Re-check drainage and edges; schedule any patching

Spring rains expose grade and shoulder problems

Mid-summer

Quick look at high-traffic lanes and drive aisles

Heat aging and heavy use open new surface cracks

Late summer to early fall

Schedule crack sealing and sealcoating

Cracks are open and dry; work cures before the wet season

After any major storm

Spot-check for new ponding and edge separation

Water is the root cause of most crack growth

Late fall

Final walk-through; photograph and budget for spring

Documents change over the year and supports next year's budget

Two full walk-throughs a year plus a quick look after major storms is the minimum. Larger lots with heavy truck traffic may need quarterly checks.

A Simple Inspection Checklist for Property Managers

Use this on your next walk-through:

  • Walk the lot in a grid pattern so no area is skipped

  • Note every crack, marking width and location on a simple lot map

  • Check for ponding spots after rain, not during a dry spell

  • Look for alligator cracking in high-traffic lanes and at entrances

Warning Signs That Move a Crack Up the Priority List

Not every crack needs immediate attention, but some should not wait for the next scheduled walk-through:

  • Width: a crack you can fit a pencil into is a working crack and should be sealed before the next wet season

  • Spidering: cracks branching into a web pattern (alligator cracking) usually signal a base problem, not just a surface one

  • Edge separation: gaps along the pavement edge let water under the lot from the side

  • Recurring cracks: a crack that reopens in the same spot after sealing points to movement underneath

Documenting Crack Growth

Keep the photos and the lot map together in a simple file. Date each entry and note what, if anything, was done.

When you can show a contractor a dated history of a crack, the conversation shifts from "what is wrong" to "what is the right fix and when." That is a better position for any property manager to be in.

Pro Tip Photograph the same cracks from the same angle each walk-through. Side-by-side photos from two years apart tell you more about crack growth than any single inspection.

Arkansas Weather and Seasonal Timing for Pavement Work

Timing matters more here than in milder climates. Our freeze-thaw cycles punish any crack that lets water in.

Late summer and early fall are the sweet spot for crack sealing. Cracks are open, surfaces are dry, and the work holds through winter.

Summer heat is hard on sealcoating application, so crews often work early in the day. Winter is for inspections and planning, not sealing.

Key Takeaway The best preventive maintenance schedule in Northeast Arkansas is built around the seasons: inspect in spring, seal in late summer, and address drainage before the fall rains.

DIY vs. Professional Crack Repair: What Actually Lasts

DIY crack repair can work for a homeowner with a few hairline cracks and time to spare. For commercial lots with traffic and structural movement, professional repair is often more effective. The difference lies in the preparation, sealant choice, and application conditions.

A Decision Guide: When DIY Is Reasonable and When It Is Not

Use this as a starting point, not a substitute for an on-site assessment:

Situation

DIY Reasonable?

Why

A few narrow hairline cracks on a residential driveway

Yes, with care

Small, shallow cracks can be cleaned and filled by hand

Cracks wider than a pencil on any lot

No

Working cracks need hot-applied rubberized sealant and proper cleaning

Alligator cracking (web pattern)

No

Usually a base failure; sealing over it hides the problem

Cracks along pavement edges or joints

No

Edge separation lets water in from the side; needs professional assessment

Cracks that reopened after a previous repair

No

Recurring cracks point to movement underneath

Commercial lot with regular traffic

No

Traffic and liability make a durable, properly prepped repair the priority

Ponding water near the crack

No

Drainage must be addressed before sealing

If your situation falls in the "No" column, a professional assessment is the right next step. It is not about selling a bigger job, it is about fixing the cause instead of the symptom.

Sealant Selection and Application Conditions

If you do decide to handle a few hairline cracks yourself, the materials and conditions matter as much as the technique.

Common sealant types:

  • Hot-applied rubberized sealant: the standard for working cracks on commercial lots. It flexes with the pavement through freeze-thaw cycles and bonds tightly to clean edges. Requires a sealant kettle and proper heating.

  • Cold-pour liquid filler: available at most home improvement stores. Easier to apply, but less flexible and shorter-lived than hot-applied rubberized sealant.

  • Cold patch: a temporary pothole repair material. It does not flex and often pops out within a season.

  • Sealcoating: a surface coating, not a crack filler. It slows sun damage and improves appearance but will not fix an open crack.

Application conditions that matter:

  • Surface must be dry. Sealing over a wet crack traps moisture underneath and the seal fails within a season.

  • Crack must be clean. Dust, debris, and old failed filler must be removed, usually with compressed air and a wire brush or router.

  • Temperature matters. Hot-applied sealant needs the pavement and air warm enough for proper bonding; cold-weather application is a recipe for early failure.

  • Curing time before traffic. Freshly sealed cracks need time to set before vehicles roll over them. Ask your contractor about reopening timing for your lot.

Why Preparation Is the Whole Game

The honest comparison comes down to preparation. Dust, debris, and moisture are what kill a seal.

We are a veteran-owned, family-owned, licensed contractor. DIY patches often crack again within a year, indicating that the fix was never the filler, but rather the preparation.

If you want a repair that lasts, get a professional assessment. You can request an evaluation through armorasphalt.rocks.

Frequently Asked Questions

What causes asphalt to crack?

Asphalt cracks come from a mix of water intrusion, temperature swings, traffic loads, and age. In Northeast Arkansas, repeated freeze-thaw cycles in winter and intense summer heat expand and contract the pavement. Water seeps into hairline cracks, weakens the pavement base, and speeds up surface deterioration. Heavy vehicles and poor drainage make it worse. Catching these causes early is the first step to prevent asphalt cracks from spreading into potholes and costly repairs.

Does sealcoating prevent asphalt cracks?

Asphalt sealcoating does not stop every crack, but it slows surface deterioration by blocking water, sunlight, and chemical damage. A fresh sealcoat protects the asphalt surface and extends pavement life when paired with crack sealing and good drainage. Sealcoating is not a substitute for structural repair, and it will not fix alligator cracking or base failures. Schedule it after cracks are filled and the surface is clean for the best results.

When should asphalt cracks be sealed?

Seal cracks once they are wide enough to hold sealant, before water reaches the pavement base. In Arkansas, the best windows are dry stretches in spring and early fall when temperatures are mild and rain is not forecast. Cleaning cracks, drying the crack, and applying hot-applied rubberized sealant during good conditions helps the repair last. If a crack has spread into alligator cracking or a pothole, patching or pothole repair may be needed instead.

Can you use polymeric sand to fill cracks in asphalt?

Polymeric sand is made for paver joints, not asphalt cracks. It does not bond well to asphalt, washes out with rain, and can make the crack worse by trapping moisture. For asphalt crack repair, use a hot-applied rubberized sealant or a proper cold-patch product for small fixes. Cleaning cracks and drying the crack first matters more than the filler brand. For parking lots and driveways, professional asphalt crack sealing gives a longer-lasting result.

Small cracks are easy to ignore until they become a pothole or a liability. Armor Asphalt helps property owners across Northeast Arkansas protect their pavement with crack sealing, sealcoating, patching, and striping. Our team handles cleaning, drying, and hot-applied rubberized sealant so the repair holds through Arkansas weather. Get started with Armor Asphalt and keep your lot safer and better looking for years. Visit armorasphalt.rocks to request a quote.

Need Help Now? Call Us!

Comments


bottom of page